RobJ
Mar 17 2007, 05:14 PM
Hello,
Has anyone here fabricated a new 13ft Boler frame? I'm considering having my rebuilt in the next couple of weeks, and I'm wonder where exactly the body is bolted to the frame. I found screws on each corner of the Boler (under the seats). Is that all there is?
Cheers,
Rob
Chester Taje
Mar 17 2007, 05:20 PM
I removed my body from frame and if memory is intact i think i had about 4 or 5 bolts/screws on each side of boler along the frame.Hope this helps.
Doug Mager
Mar 17 2007, 07:24 PM
A rodder buddy in Langley (car person) rebuilt his Boler, (lengthened it also) to better pack some of the stuff they tote around with them. I have had my bolts on my Trillium replaced by Reace at Escape but I was not privy to the # of bolts they found/replaced.
Alf S.
Mar 18 2007, 03:54 AM
Roy Massen
Mar 18 2007, 06:41 PM
QUOTE (Alf S. @ Mar 18 2007, 11:54 AM)

yes I had one under the fridge along with a couple more under the sink cabinet and one in the middle of the floor to the support.
also - one rivet under one of the wooden pieces used to make the back seats
lifted the body slowly and kept looking for where it was stuck....
finally did pop off....
Clyde Rohde
Mar 18 2007, 06:58 PM
I recently got a 1976 13' Boler. Since I 've had it, I have been striping out the inside to expose all of the screws and bolts that hold the fiberglass shell to the frame. There were a total of 4 bolts (one at each corner) and 22 screws. The ones to look out for that are well hid are the 2 that are in the closet area. They are hidding under wood strips on the floor of the closet. I finnaly got them all out and lifted the shell off the frame last weekend.
adamp
Mar 19 2007, 01:16 PM
I put my rig up on blocks so I could crawl under to find the nuts in the frame, that led me to the bolts in the body. 6 carriage bolts. I had to remove the front gaucho, kitchen, and rear dinette to get to them. Two came undone with brute force and WD40, two broke off, and I had to drill a hole through the center of two heads and drive the remains through with a punch. Watch for (and afterwards replace) a ground wire going from the coach's electrical system to the frame.
Adam
This is a "lo-fi" version of our main content. To view the full version with more information, formatting and images, please
click here.