While on the Lanesboro campout, we were plugged in to shore power. We were running a couple of our 12 volt interior
lights, and the 12 volt
porch light.
The
fridge was on, with the switch set to 110.
We went to turn the
furnace on, to take the edge off, and everything started to flicker. There is a little red
light on the inverter that comes on now when we try to run any 12v item. This
light flickers and says "Overload" below it. The
light does not flicker when only the
fridge is running by itself.
The inverter has 6 breaker switches and 4 fuses. None of the breakers were tripped, and all of the fuses seem fine.
I hope the whole thing isn't fried! Any suggestions?