I have a 1980 restored
Scamp 16'. The Bath sink empties into the gray water tank below. It is located on the left/Street side in front of the wheel well. The Kitchen sink line on the curb side goes to a male hose fitting. I run a hose (female on each end) to a sewer connection which has a male connection on the front. If I do not have sewer hookup I run it to a bucket.
Does anyone know if this was the OEM setup for the
Scamp at that time? I have considered running a line from the kitchen sink to the gray water tank, but it would mean removing the tank to install the inlet line.
Any comments?