I must say…. When my
Scamp door was hung at the factory the person that did the work must have been drunk or stoned.
The upper hinge was OK but the lower wasn't even close to horizontal. All in all the entire door was not straight.
It wasn't even cut correctly…..
The unfinished front edge had a wave you could surf on.
Anyway……
Today I removed the door, put a tape line on the long sides, worked them over with my grinder and re-drilled the lower (door side) hinge holes.
The result……
Now my door has parallel hinges, straight sides and fits the door frame correctly.
Took about an hour.