Will this fit my Scamp?

[Russ V.]

Will this fit my camper? I want to put a wheel on the jack instead of the plate, but I'm not sure if this is the right size.

http://www.campingworld.com/browse/skus/in...el/skunum=17978

Thanks,

Russ

[Pete Dumbleton]

Maybe or maybe not. Things are not standardized between manfs of tongue jacks.

[Donna D.]

It says Jack tube size of 2”. I suppose you could measure the one on your trailer?

[Russ V.]

Maybe or maybe not. Things are not standardized between manfs of tongue jacks.

...or even with the same manufacturer I suppose.

I'll have to do as Donna suggested and measure, but I don't think it's 2".

Does anyone have one that they put on a Scamp, or did yours come from the factory with a wheel?

[james kent]

If Your jack is a swing up I can't see any problem but, if your jack is in a permanently verticle position then you may not have enough ground clearance when driving.

[Greg A]

If I recall right, they sell the entire replacement tongue jack with a wheel for about $20 at Harbor Freight.
I'd just replace the entire piece.

One example: tongue jack

[Roger H]

If Your jack is a swing up I can't see any problem but, if your jack is in a permanently verticle position then you may not have enough ground clearance when driving.

You remove the jack wheel when towing. That's why it has the pin.

Roger

[Russ V.]

If I recall right, they sell the entire replacement tongue jack with a wheel for about $20 at Harbor Freight.
I'd just replace the entire piece.

One example: tongue jack

Mine is the A-frame jack that cranks straight up, so that one won't work.