|
03-12-2006, 07:21 PM
|
#1
|
Member
Trailer: 75 Boler
Posts: 72
|
OK, as Donna or Gina pointed out, removing the backrest support is forever....so it got me thinking. What I really need is the extra depth space while my wife or I sleeps on the couch.
I'm now thinking that I split the back cushion length wise...you with me? I will then have two backrests that will be reupholstered...but not together. I can then have the two pieces connect via strong snaps (a couple on heach upper and lower half). Come nighttime, I unsnap the upper from the lower and I have the extra width while laying down. Of course I'd still have to store the bottom piece in my tow but no big woop.
This way, it retains the "stock appearance" but provides a wider sleeping area without raising the back into the bunk config....laying on the bottom makes feel like I'm in a cave.
Any thoughts?
Dan
|
|
|
03-12-2006, 08:34 PM
|
#2
|
Senior Member
Trailer: Boler (B1700RGH) 1979
Posts: 5,002
|
Makes sense to me, Dan, but I'm not sure it gains much over just putting a nice cover on the hinge area and removing the whole back cushion.
I understand both the desire to gain width, and the "cave" effect, having considered this setup in possible replacement trailers (our current B1700 has a much wider gaucho). Could the backrest hinge be arranged to allow the backrest to hinge up further, like 180 degrees, flat against the window? Curved body corners will cause problems, but perhaps small end sections could be left fixed in place and still gain width in the important middle section.
__________________
1979 Boler B1700RGH, pulled by 2004 Toyota Sienna LE 2WD
Information is good. Lack of information is not so good, but misinformation is much worse. Check facts, and apply common sense liberally.
STATUS: No longer active in forum.
|
|
|
03-12-2006, 09:17 PM
|
#3
|
Member
Trailer: 75 Boler
Posts: 72
|
Brian,
That might work as well, just do not know where/what would hold it up.
AAAUUUGGHH.....I so want a 17. However, financially I have competing priorities...like a new roof.
Dan
|
|
|
03-12-2006, 09:21 PM
|
#4
|
Senior Member
Trailer: TrailManor (Gone to the Darkside)
Posts: 466
|
I suppose the main question I'd have is: Why the strong desire to maintain the stock appearance?
If I could propose an alternate for the front end... How about pulling everything out and putting in a small dinette instead? If you design it so the table drops - you can have it convert into a bed when you want it. Gives a lot of flexability.
Mike
|
|
|
03-13-2006, 01:42 PM
|
#5
|
Senior Member
Trailer: Boler (B1700RGH) 1979
Posts: 5,002
|
Quote:
...just do not know where/what would hold it up.
...
|
Nothing holds up the back cushions of either the dinette seats or the gaucho in my B1700 - they just rest against the walls, with varying degrees of success. I'm not usually a fan of hook-and-loop fastening (like Velcro), because it is so often used in inappropriate applications, but this might be a good place for it.
__________________
1979 Boler B1700RGH, pulled by 2004 Toyota Sienna LE 2WD
Information is good. Lack of information is not so good, but misinformation is much worse. Check facts, and apply common sense liberally.
STATUS: No longer active in forum.
|
|
|
03-14-2006, 07:47 AM
|
#6
|
Senior Member
Trailer: 1988 16 ft Scamp Deluxe
Posts: 25,711
|
I'd leave the support, remove the hinged back for the bunk bed setup (and store it in the garage in case of a future sale of the trailer) and use some big fluffy pillows for the back rest when wanting to use the setup as a couch. The support on my Scamp is a good 18 inches or more above the base of the couch and wouldn't be in the way in the least when laying down to sleep. You could even use the hook'nloop stuff on the support to keep the fluffy pillows attached to the support, if necessary. Snapping the pillows/cushions together wouldn't be necessary with this method.
My 2 cents.
__________________
Donna D.
Ten Forward - 2014 Escape 5.0 TA
Double Yolk - 1988 16' Scamp Deluxe
|
|
|
04-23-2006, 11:11 PM
|
#7
|
Senior Member
Trailer: Love Bug 1974
Posts: 328
|
Hello!
I couldn't stand sleeping under the top bunk, I'm a bit claustrophic but, I wanted to use the original backrest. I simply removed the top bunk from the hinges and at night, I pull that onto the base and put the other cushion from the seat on top of this. I gives more width and is extra comfy with two layers of foam. I still leave that small pillow in the curve and there is a smallish gap, but, it doesn't bother me. A person could easily make another of the same and not have any space at all. I'd try this before I went to a lot of expense and see if it works for you. You could always reattach, if wanted.
The throw pillows I have on the couch are two sacks with a cool drawstring that stores neatly folded linens from my bed. Pillows by day, quilt by night...
The pillow covers are much like a pillow case, only square, with a drawstring. I made them easily. A person could also make these with a center seam that velcros shut, or buttons, or zippers. They are great space savers and give a nice, comfortable backrest.
|
|
|
04-24-2006, 01:17 PM
|
#8
|
Senior Member
Trailer: 1970 Boler
Posts: 374
|
You can also make a small shelf out of the backrest support. Check out my website and you can see the picture. I am doing the opposite as you but at least the support was left in place for me. We use the shelf for small items that rooll around while towing such as salt and pepper shakers and flash lights.
|
|
|
04-24-2006, 03:19 PM
|
#9
|
Senior Member
Trailer: 1986 U-Haul CT13 ft
Posts: 494
|
For anyone other than an agile adolescent, the gaucho bunks are useless. And I don't know of any egg collectors who insist on everything being kept original. So we just unscrewed the hinge holding the UHaul backrest/upperbunk and got rid of it. Now the front seat cushion makes a comfortable spot for napping and - with the addition of a few pillows - an occasional couch or bed for guests.
|
|
|
04-24-2006, 03:25 PM
|
#10
|
Senior Member
Trailer: 1988 16 ft Scamp Deluxe
Posts: 25,711
|
But the U-haul doesn't have the support fiberglassed in like on the Scamp's and Boler's does it It's a major decision for those owners whether or not they ever want the ability to put the goucho back together (like resell reasons). But, I've found the support is high enough it certainly wouldn't bother someone sleeping and some big overstuff pillows probably wouldn't notice it either when use the "couch."
__________________
Donna D.
Ten Forward - 2014 Escape 5.0 TA
Double Yolk - 1988 16' Scamp Deluxe
|
|
|
04-24-2006, 06:28 PM
|
#11
|
Senior Member
Trailer: 1986 U-Haul CT13 ft
Posts: 494
|
Quote:
But the U-haul doesn't have the support fiberglassed in like on the Scamp's and Boler's does it
|
Dunno what others have. The UHaul has a narrow shelf-like projection molded into the interior below the front window. It supported the long gaucho hinge, and makes it uncomfortable as a backrest without adding cushions.
I don't hold with the idea of diminishing my own pleasure in a possession in order to please some possible future buyer. Reminds me of those horrible plastic slipcovers people used to put on their couches, making people uncomfortable now to protect the upholstery for next year.
|
|
|
04-24-2006, 06:42 PM
|
#12
|
Senior Member
Name: Myron
Trailer: Escape
New Mexico
Posts: 987
|
Burro, of course, has the same thing, a shelf made from a strip of 3/4 plywood about 3 inches wide thats fiberglassed permanently in place.
Have no use for a goucho-ma-callit-upper bunk, (what's the origin of "goucho," here, anyway?*) so I used it as a support to screw in this thing I made that has a fold-away mini table. Up under the window I added a narrow shelf for pencils and salt shakers (whatever).
*A goucho's a guy who wears a flat brimmed hat with little ball tassels around it, and rides the pampas, right??
|
|
|
04-24-2006, 07:02 PM
|
#13
|
Senior Member
Name: Myron
Trailer: Escape
New Mexico
Posts: 987
|
Here the small table is folded away but obviously this still wouldn't make a very comfy backrest, either. Still searching for the right color and design in a throw pillow, or three.
|
|
|
04-24-2006, 07:13 PM
|
#14
|
Senior Member
Trailer: 74 13 ft Boler and 79 17 ft Boler
Posts: 568
|
Gaucho/ goucho bed is the terminoligy for a dual purpose couch bed....maybe the origin of the name came from gauchos having to use them when running cattle or after getting loaded in the cantinas.. ...latter probably the right answer......Benny
|
|
|
04-24-2006, 07:22 PM
|
#15
|
Senior Member
Name: Myron
Trailer: Escape
New Mexico
Posts: 987
|
Yes, that sounds right. Originally they were like dual-purpose saddles, so a fella could still catch a few winks when riding herd on bulls during siesta time.
Knew I spelled it wrong.
|
|
|
04-24-2006, 10:32 PM
|
#16
|
Senior Member
Trailer: 2002 Casita Freedom Deluxe / 2007 Nissan Frontier King Cab
Posts: 733
|
Heh heh. I like that photo.
|
|
|
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
|
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
Similar Threads
|
Thread |
Thread Starter |
Forum |
Replies |
Last Post |
An idea..
|
Sharon Herman |
General Chat |
6 |
11-23-2008 12:43 PM |
hook up idea
|
andre robillard |
Modifications, Alterations and Updates |
1 |
04-25-2007 04:28 PM |
Idea??!!
|
Veronica81 |
General Chat |
11 |
04-27-2006 11:37 PM |
Replacing backrest
|
Dan Simon |
Problem Solving | Owners Helping Owners |
10 |
03-11-2006 10:52 AM |
|
» Recent Discussions |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
» Upcoming Events |
No events scheduled in the next 465 days.
|
|