Finally replaced the original Bargman 92 series
lights with LED Bargman 07 series. So much brighter! Wiring was pretty straight forward... ended up removing the table, passenger side bench to access the wire bundle to wire into the main
Scamp wiring. Did not remove the driver's side bench b/c of the converter and an
electrical outlet are mounted into the bench and did not want to unwire all that.... so did a nice headstand in the hatch to access the wiring on that side. The wires mate up under the rat fur about 8" up from the floor so made a little slit into the fur for access (it is hidden behind the benches so doesn't show). Sealed the
light to the
Scamp by stuffing 1/2" closed-cell backer rod (also known as caulk saver poly cord) into the channel around the edge of the
light. Made a nice seal. Two of the screw holes matched up perfectly; had to drill 2 new holes. Sealed the old holes with PC-11 marine epoxy and caulked where the wires enter in from the outside. Purchased from eTrailer.
Since the table and bench are out.... replacing carpet with Allure flooring...will post when complete.
Back of
light
Basic wiring: