In order to install two Unisolar ePV68
solar panels on the starboard side of the
Bigfoot roof, two mounts for the roof rack will need to be removed. I've looked for posts on this subject but have not found any that specifically address this issue, so i have a couple of questions:
I believe the Plas-T-Cote sealing the mounts will come off just by scraping, but will a heat gun help soften it up?
Should the screw holes be patched with resin and
fiberglass, then covered with gel coat? I'm thinking since the screw holes are so small that they could be filled with gel coat only.
Thanks for your ideas.