Shelving in the closet, formica counter in place of the sink and stove.
need to add extra plywood to support the edges of the dinette cushions in bed mode.
Exterior
none - yet.
starting with a good cleaning and vertglas.
upgrade to LED tail lights?
UPDATE:
Vertglas part done - the oxidation removal part... more to go yet..
Frame removed, new axle added (with brakes), frame mods: reinforcement was already done, tabs to bolt the fiberglass body to the frame already added, we added a removable spare tire mount under the body of the boler (where the water tank goes - if I put a water tank back in this is very easily removable). Also welded on trailer receivers on the back bumper. Why you say? well, we put a 2" in the center for future bike carrying and future spare tire mount. We added 2 1.25" to each side of that out towards the outside - this is my mount for a rear box - quickly removable. Frame cleaned off (wire brushed, ground, sanded, scrubbed, power washed) and then painted with tremclad rust primer and tremclad flat black. Looks much better, but not quite done.
Customization
none - yet.
For the Electrical:
* RV Converter/Chargerr? Inteli-power: PD9245CR 45 AMP ~ $149.00
* Inverter? 1200 Watt unit?
* LED Lights
* speakers,
* ipod doc,
* computer, cell phone, camera, AA battery charging
* rear receivers, 2" in the center and a 1.25" on each side to support a rear box. 2" for bike rack, spare tire mount, whatever?
Renovations
none - yet
put new ST tires on (purchased a new spare too)
need to check frame for reinforcing
bought vertglas - have not had time to apply it yet.
looking at ordering scamp cushions
trailer brakes!
Frame clean up and painted.
Other Information
we have an awning, but no mounting rail, so we need to fabricate something better to hold it in place. In low wind situations we tension a length of climbing webbing from bumper to hitch over the top which goes over the edge of the awning holding it in place.