Adding Rooftop AC to Parkliner - Fiberglass RV
Journey with Confidence RV GPS App RV Trip Planner RV LIFE Campground Reviews RV Maintenance Take a Speed Test Free 7 Day Trial ×


Reply
 
Thread Tools Search this Thread Display Modes
 
Old 07-09-2018, 01:54 PM   #1
Junior Member
 
Name: robert
Trailer: parkliner
Michigan
Posts: 21
Adding Rooftop AC to Parkliner

Recently learned Parkliner has gone to rooftop AC. wondering what it would take to get that instead of the lousy floor AC. I assume main difficulty would be running the wires? Anyone do it? Replace the existing escape hatch with AC?
bbard is offline   Reply With Quote
Old 07-10-2018, 10:05 AM   #2
Member
 
MurrayC's Avatar
 
Name: MURRAY
Trailer: Ventura
British Columbia (BC)
Posts: 92
Robert
Make sure your roof will support an AC unit. Sure it might at first sight but going over bumps and highway vibration can take a toll on roof with weight on it.
Not saying its a bad idea but look into it first.
Enjoy
MurrayC is offline   Reply With Quote
Old 07-10-2018, 10:48 AM   #3
Senior Member
 
Trailer: Scamp 16 ft Side Dinette
Posts: 1,279
Let me know, when you find out.
We also have the A/C under the side seat. Poor performance is likely because of poor air circulation around the back of the unit.
Wayne Collins is offline   Reply With Quote
Old 07-10-2018, 03:06 PM   #4
Senior Member
 
George Lauver's Avatar
 
Name: George
Trailer: 85 Uhaul CT 13
North Carolina
Posts: 195
I planning on doing this mod this winter. I have purchased a marine Koosa Board, I believe that's how you spell it, to epoxy to the roof for extra support. I'll cut a 14 1/4 x 14 1/4 inch opening to mount unit. The board is 1 " thick so I'll notch out the bottom side to run the wire to the side and then down to the breaker box.
George Lauver is offline   Reply With Quote
Old 07-10-2018, 03:18 PM   #5
Senior Member
 
Trailer: Scamp 16 ft Side Dinette
Posts: 1,279
What model of A/C are you using? Perhaps a Low Profile one of 9 inches or less high.
We have an roof overhang, where we store the trailer, that limits the total height.
The Parkliner roof has a trough in the center that helps to hide the roof vent and A/C.
Wayne Collins is offline   Reply With Quote
Old 07-10-2018, 03:33 PM   #6
Senior Member
 
George Lauver's Avatar
 
Name: George
Trailer: 85 Uhaul CT 13
North Carolina
Posts: 195
Yes, the Penguin 2 low profile, 11k btu.
George Lauver is offline   Reply With Quote
Old 07-10-2018, 03:34 PM   #7
Senior Member
 
George Lauver's Avatar
 
Name: George
Trailer: 85 Uhaul CT 13
North Carolina
Posts: 195
2014 ParklinerClick image for larger version

Name:	20180710_162945.jpeg
Views:	28
Size:	159.3 KB
ID:	121755
George Lauver is offline   Reply With Quote
Old 07-10-2018, 03:36 PM   #8
Senior Member
 
George Lauver's Avatar
 
Name: George
Trailer: 85 Uhaul CT 13
North Carolina
Posts: 195
Sorry about that, don't know how 2 copies where sent?
George Lauver is offline   Reply With Quote
Old 07-27-2018, 11:07 AM   #9
Senior Member
 
Trailer: Scamp 16 ft Side Dinette
Posts: 1,279
Quote:
Originally Posted by Wayne Collins View Post
What model of A/C are you using? Perhaps a Low Profile one of 9 inches or less high.
We have an roof overhang, where we store the trailer, that limits the total height.
The Parkliner roof has a trough in the center that helps to hide the roof vent and A/C.
The Coleman Mach8 Low Profile A/C is just 8 inches high - on top of the roof - but has an inside part that hangs down 3 or 4 inches under the ceiling. Not so good for a tall guy.
Unless, the A/C can be located where the MaxxFan is over the bed, and the MaxxFan is moved forward???
Wayne Collins is offline   Reply With Quote
Old 08-14-2018, 12:55 PM   #10
Junior Member
 
Name: Bill
Trailer: Parkliner
North Carolina
Posts: 8
Registry
Bbard, Let me know what you find out, for I would like to do the same on my PL.
Wpuvy is offline   Reply With Quote
Old 08-14-2018, 01:08 PM   #11
Senior Member
 
Raspy's Avatar
 
Name: John
Trailer: Roamer 1
Smith Valley, Nevada
Posts: 2,880
Quote:
Originally Posted by bbard View Post
Recently learned Parkliner has gone to rooftop AC. wondering what it would take to get that instead of the lousy floor AC. I assume main difficulty would be running the wires? Anyone do it? Replace the existing escape hatch with AC?
Are you ready for all the noise?

I wish my Oliver did not have a roof AC as it's too loud, adds weight where you don't need it and sticks up to add a lot of overall height. You'll also need a condensate drain unless you just let that run down the side of the trailer.

Oliver switched to the Penquin from the Mach 8 because the Penguin is quieter, but that doesn't mean it's quiet.

Have you looked into making your existing setup work better? Maybe correct any ventilation problems in the back to separate the vents, or adding a room fan? Maybe a muffin fan strategically located?
__________________
I only exaggerate enough to compensate for being taken with a grain of salt.
Raspy is offline   Reply With Quote
Old 08-16-2018, 09:48 AM   #12
Senior Member
 
frank_a's Avatar
 
Name: Frank
Trailer: 2012 ParkLiner #006
New York
Posts: 2,273
Even in the scorching days of high heat and humidity camping a month ago for a week on the eastern shore of Lake Erie, our AC performed very well, though it puts out a prodigious amount of water. We learned years ago that the front of the unit must be propped up a bit for the water to drain as intended. We have a small electric fan we put in front of it to blow air upward. I like not having it on the roof!

Frank
__________________
2012 ParkLiner #006
2013 4wd 4 door F150 3.5L Ecoboost with 9200# tow package
frank_a is offline   Reply With Quote
Old 08-17-2018, 02:55 PM   #13
Junior Member
 
Name: Sandra
Trailer: ParkLiner #000
North Carolina
Posts: 24
Contemplating Roof Air

I too am contemplating the roof mounted air conditioner. However, a small fan helps during the day. At night, the air + fan is very cold.

Also, I am considering the Fiamma awning. When traveling in the West, direct sunlight caused the refrigerator to have a melt down. My hesitation is that of adding holes to the body. Logically, I want to avoid any cracks or holes. What have been your experiences with the installed awnings?
SandraT is offline   Reply With Quote
Old 08-17-2018, 03:27 PM   #14
Senior Member
 
Trailer: Scamp 16 ft Side Dinette
Posts: 1,279
Fiama Awning Mount

Yes, you do need to drill holes through the shall to properly install a Fiama.
That lets you put large diameter "fender" washers on the inside to spread the load over a larger area.
They will be located inside the upper cabinets and front closet where they don't show.
Wayne Collins is offline   Reply With Quote
Old 08-17-2018, 03:40 PM   #15
Junior Member
 
Name: Sandra
Trailer: ParkLiner #000
North Carolina
Posts: 24
Have you ever had any cracking or leaking problems at the holes where the awning was installed?
SandraT is offline   Reply With Quote
Reply

Tags
parkliner


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off


Similar Threads
Thread Thread Starter Forum Replies Last Post
Rooftop AC on a Parkliner? frank_a Problem Solving | Owners Helping Owners 0 09-14-2015 12:01 PM
A/C - Adding a Rooftop Unit Stephan G Ryan Care and Feeding of Molded Fiberglass Trailers 6 07-22-2010 08:10 PM
rooftop a/c nick c Modifications, Alterations and Updates 5 11-09-2008 08:31 AM
Rooftop carrier Modifications, Alterations and Updates 0 01-01-1970 12:00 AM

» Upcoming Events
No events scheduled in
the next 465 days.
» Featured Campgrounds

Reviews provided by


All times are GMT -6. The time now is 03:30 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.