Hi, just a quick note to say that we purchased a gutted 72
Boler, which has a small area which is slightly concaved on the back right corner, and also the middle of the roof where the vents are located is also low, e.g you can push it up by hand, but it goes back down when you release it.
Can anybody provide us with some insight as to what we could do to rectify this problem without removing the insulation on the inside (if possible)? We're not sure if that area should be cut out and replaced with new fibreglass, etc before we primer and re-paint....
Your thoughts and ideas are VERY MUCH appreciated
!
Cheers!
Wes and Deb