Hi, I'm new to the site. I bought my
Burro this summer and am in the process of getting it ready for use. I have repaired and replaced some of its parts but my biggest problem is the fit of the door. I pulled the door seal off of the trailer and am now trying to get the door shape to match the lip that is built into the trailer. The middle of the door touches the frame. The top of the door is about a half of an inch from the frame and the bottom is about 1.5" from it.
I have cut the bottom of the door in half about a foot up and removed the wood and
fiberglass to allow for the door to bend. I have also cut the top in half a couple of inches down to help shape that too.
Is there anyone out there that has come upon this problem with these
fiberglass trailers? Thanks!