Anyone know how to remove the original
lights in the
Burro without messing up the
fiberglass too much?
The
lights I'm referring to are the square
lights on either side of the cabinets above the sink/stove. I see where they are screwed through the
fiberglass with two screws each (mine have been heavily pained over on the back side). I can't quite figure out how to get to the head of the screws to take them out, there has to be a way to open these lights - I mean people had to change the
light bulbs at some point right?
Any help is greatly appreciated - I tugged and pulled as much as I was comfortable with, but I worry about damaging the
fiberglass.