We think we've discovered that the
Boler is not being held to the frame anywhere!! From reading the forums, I think I should be seeing screw heads/washers under the couch (3 on each side?), in the closet and under the sink by the wheel well, under the table benches (2 or 3 on each side?), and one right in the middle of the floor (?). Of all those places, I see ONE screw... And just empty holes for the others...
Thankfully, we haven't towed it very far - just the less than a km from PO to our house, and then to the mechanic to get
axle and wheel bearings looked at. The mechanic said he wasn't 100% sure how the
Boler was attached to the frame.
So, what's the solution?? I've read some threads on here that say I could just get larger lag screws so they'll bite into the frame/shell again. I've also read other threads where people are reinforcing their frames with angled new pieces of frame?
Needless to say, this has made us very nervous, but very thankful we hadn't hit the open road yet!
Thanks for any and all advice!
Sarah