Grant, I doubt you'll find a new mech. to replace that broken one there for the front window cover. I'd have someone machine a new pin if it were me. if you don't care about what it looks like i'm sure you could drill a whole threw the centre of that tube part that comes off the flat flange and then put a bolt threw that tube/hole and drill a hole in that bolt to correspond with the hole in the tube thing there and then put a removable pin threw it to hold it. and when you get to your destination take the pin and the bolt out and your good to go.
but I really can't see you finding a replacement pin? there may be a possibility you could use a long bolt cut all the threads off it so its smooth and then cut a notch into it at a specific point (would have to do some measuring) then slide the bolt in the hole it goes into there and then put a spring in/over the bolt from the inside of the dish/window cover there and then put a snap ring into the notch/slot you made.
if you can't get one machined or find one used or new then that might be the best option if you can follow what i'm saying.
good luck
|