I’m repairing the right rear corner jack stand support on my 1989 Bigfoot
truck camper. There was some water damage that resulted in the jack stand support post getting soft and the top shell bottom shell backing strip getting soft as well. I’ve removed the rear closet to the bare shell and am
Now planning to reassemble. I’m looking for recommendations for the adhesive to fasten the support post to the shell, contact cement to fasten the styrofoam to the shell and the 1/8” plywood to the styrofoam.
The original contact cement seems to be a red water based contact cement. I’m planning to replace the old support with a similar 1/2” + 5/16” plywood lamination glued and screwed.
Any recommendations and sharing of similar repair would be appreciated.