Mounting PD4045 in bench?

[Bluetang99]

At first I wanted to install the pd4045 fuse box on the left side of the cabinet where the sink is but then I thought this might not be a good idea since the cabinet is structural.

So then I thought about mounting it in the rear bench opposite the water tank. Will a hole that big to fit the fuse panel jeopardize the integrity of the bench when you sit on it?

[Borrego Dave]

As long as any cutout is in the flat it won't make a difference, the corners are the strong point.

[mary and bob]

I did a similar install in our Uhaul. I made the corners of the cut slightly rounded and reinforced the opening with a piece of plywood and a strap brace to the floor.

[Bluetang99]

Ok if it doesn't make a difference then it will probably go in the kitchen counter. It will be allot easier to work with the benches removed from the camper.

[Bob in Mb]

Must be out of reaching distance of the sink not only for safety from electrical shock but possible damage from water spills.

[Bluetang99]

Originally Posted by Bob in Mb

Must be out of reaching distance of the sink not only for safety from electrical shock but possible damage from water spills.

I guess under the bench it is then. I'll just have to use it laying it on the floor temporarily until the benches get installed