The interior was totally gutted, including all the wood framing and the floors. New 3/4" framing was glued into place, matching the placing of the original except for the roof. I decided to use 2" cedar lumber to reconstruct the roof framing. This was cut to follow the roof curvature as closely as possible. I intend to panel the inside with 1/8th" vinyl coated panelling in white.

Numerous fibreglass repairs were done to the exterior, especially around the bottom. The fibreglass body was sanded down and repainted with marine paint.
The broken frame was properly repaired and a new torflex axle was installed.

The interior layout will be changed somewhat. There was no fridge when purchased, so a new 12volt DC fridge with a danfoss compressor was purchased. It will be installed on the opposite side and raised up about 18" for easier access.

2007 Kia Rondo V-6