Hello,
I would like to install a
propane furnace in my
Boler but I am not sure if it will fit properly. The opening that I am considering is under the sink, over the wheel. The dimensions of the opening: Depth: 18 3/4 " ; Height and width: 12 1/2 "
A couple of furnaces that I have seen online have a cut out depth opening requirement of 20 inches deep and 21 inches deep. Does anyone have an opinion on using one of these
furnace in the opening I have described?
Although the recommended cut out opening does not meet the manufacturers' specs, would it work if there was either a slight protrusion outside the surface of the cabinet? Other options or suggestions?
Clyde