Scamp with bathroom water line routing

[Riomcoupe]

Hello,
I have recently began remodeling my 1988 Scamp16. I am running all new water lines but hit a bit of a road block. I have the lines ran from the shower and toilet but am confused about how to run the lines from the tank to the electric water pump and to the sink. Also the grey water tank has two connections in the floor and I am not sure which lines run to it. I am also not sure where the city water line is supposed to tie into. I have the Scamp manual that shows the water lines but I am hoping for some more detail. Any help would be greatly appreciated.

[gordon2]

Originally Posted by Riomcoupe

Hello,
I have recently began remodeling my 1988 Scamp16. ..

Did you see my reply on Facebook? If not, here it is again...

I think this is all correct.. the city water needs to merge into the main water supply line anywhere except between the pump and the tank. The bathroom pipe goes to the gray tank on the port side by the sewer dump (not shown).

[Riomcoupe]

That is definitely a great start! Thank you. Do you have any more pictures like this that show underneath the sink area where the city water inlet is located?

[gordon2]

Originally Posted by Riomcoupe

That is definitely a great start! Thank you. Do you have any more pictures like this that show underneath the sink area where the city water inlet is located?

Mine is layout four with the sink on the starboard side. IIRC the city water inlet tees in to the cold line just below the inlet. (Replies and photo updated).